11/20/2023 0 Comments Router reflectorWhen you enter theĪddress-family command from router configuration mode, you enable the addressįamily and enter global address family configuration mode.Īddress family must be configured in router configuration mode beforeĬonfiguring the IPv4 labeled-unicast address family for a neighbor in neighbor If you suspect user group assignment is preventing youįrom using a command, contact your AAA administrator for assistance.Ĭommand to enter various address family configuration modes VRF neighbor configuration (IPv4 address families) Command HistoryĬommand, you must be in a user group associated with a task group that includes An address family must be configured in router configuration modeīefore it can be configured under a neighbor. Under the neighbor for the BGP session to be established for that addressįamily. Similarly, an address family must be configured Must be explicitly configured in the router configuration mode for the addressįamily to be active in BGP. VPN Version 4 (VPNv4) unicast address prefixes. Neighbor configuration mode and VRF neighbor configuration mode. IP Version 4 (IPv4) unicast address prefixes. This chapter provides details of the commands used for configuringīorder Gateway Protocol (BGP) Route Reflector (RR).Īddress family configuration modes while configuring Border Gateway ProtocolĬommand in an appropriate configuration mode. Link Layer Discovery Protocol (LLDP) Command Reference.Authentication, Authorization, and Accounting Commands.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |